Raritan PCS12 Uživatelská příručka stáhnout pdf (Strana 18)

Chapter 3: Prepare Raritan Devices

3. Follow the prompts to change the default password. Please refer to

Raritan's KX II User Guide for details. Be sure to make a note of the

new password.

4. You will receive confirmation that the password was successfully

changed. Click OK. The Port Access page is displayed.

5. Select Device Settings > Network Settings.

6. Specify a meaningful Device Name for your Dominion KX II unit; up

to 16 alphanumeric characters, special characters, and no spaces.

7. Select None (Static IP) from the IP auto configuration drop-down list:

8. Type the TCP/IP parameters for your Dominion KX II unit: IP

address, Subnet mask, Gateway IP address, Primary DNS server IP

address, and (optional) Secondary DNS server IP address.

9. Click OK to save the settings. Restart the Dominion KX II unit.

Connect to Network and Attach Servers

Dominion KX II uses standard UTP cabling (Cat5/5e/6) to connect to

each target server.

1. Connect a standard Ethernet cable (included) from the network port

labeled LAN1 to an Ethernet switch, hub, or router.

2. To connect a target server to Dominion KX II, connect the

appropriate Computer Interface Module (CIM). Please refer to

Raritan's Dominion KX II User Guide for details.

3. Attach the HD15 video connector of your CIM to the video port of

your target server. Ensure that your target server's video has already

been configured to a supported resolution and refresh rate. For Sun

servers, also ensure that your target server's video card has been

set to output standard VGA (H-and-V sync) and not composite sync.

4. Attach the keyboard/mouse connector of your CIM to the

corresponding ports on your target server. Using a standard

straight-through UTP (Cat5/5e/6) cable, connect the CIM to an

available server port on the back of your Dominion KX II unit.

Dominion KX II-101

The following section provides you with the necessary background

information and steps to install and configure Raritan Dominion KX II-101

units to conform to CC-SG's requirements.

Note: Be sure to document the device name, IP address, administrative

username and password, and attached systems (port number, type,

system name) in Installation Template (on page 53).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 69 70

Žádné komentáře

Raritan PCS12 Uživatelská příručka Strana 18