Raritan PCS12 Uživatelská příručka stáhnout pdf (Strana 24)

Chapter 3: Prepare Raritan Devices

Video connection to local monitor (optional cable).

Local monitor.

USB connection from target server to mouse.

USB connection from target server to keyboard.

Target server.

Connecting to the Network

Connect a standard Ethernet cable from the network port labeled LAN to

an Ethernet switch, hub, or router. The LAN LEDs that appear above the

Ethernet connection indicate Ethernet activity. The yellow one blinks

while the Dominion KX II-101 is in use, indicating IP traffic at 10Mbps.

The green light indicates a 100Mbps connection speed.

Powering the Dominion KX II-101

The Dominion KX II-101 can be powered with either the included

standard AC power pack or by PoE (Power over Ethernet).

• For standard AC power, plug the included AC power adaptor kit into

the Power Port and plug the other end into a nearby AC power

outlet.

• For PoE, attach a 10/100Mbps cable to the LAN port, and plug the

other end into a PoE-provisioned LAN.

After Dominion KX II-101 is powered ON, it goes through a boot-up

sequence, during which the blue Raritan-logo LED will blink for about 45

seconds. Upon successful boot-up, the back-lit LED remains lit.

Using the Admin Port

The Admin port enables you to perform configuration and setup for the

Dominion KX II-101 using a terminal emulation program like

HyperTerminal. Plug the min-DIN end of the included serial cable into the

Admin port of the Dominion KX II-101 and plug the DB9 end into a serial

port on your PC or laptop. The serial port communication settings should

be configured to: to 115,200 Baud, 8 data bits, 1 stop bit, no parity, and

no flow control.

For information about configuring the Dominion KX II-101 using the

ADMIN port, see Using a Terminal Emulation Program in Raritan's

Dominion KX II-101 User Guide.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 69 70

Žádné komentáře

Raritan PCS12 Uživatelská příručka Strana 24